INFLUENCE GEOMETRIC PARAMETER SAWS ON HIS(ITS) CAPACITY TO WORK

Authors

  • Imomkulov SHuhratzhon Boqizhonovich Namangan Engineering Technological Institute, Department of General Technical
  • Abdukahhorov Zohidzhon Namangan Engineering Technological Institute, Department of General Technical

Keywords:

the worker surface, saw, stability

Abstract

At present is absent the scientific motivation geometric parameter separating saws and rates to accuracy functional parameter. The Question to optimization geometric parameter saws is important and in this connection requires the immediate permit. In article is considered questions bound change of power acting worker of the surfaces teeth saw depending on designs

References

Fedorov V. S. Technology of primary processing of raw cotton, Gilegprom. 1937

Levkovich B. A. Elements of the theory of gining. Gosizdat UzSSR. Tashkent, 1938

Saidov H. About the rational profile of the tooth of the genie saw, Yangi Technology Magazine. GIT UzSSR by coordination. n/a of works No. 3. 1962, pp. 22-24.

Levkovich B. A. Rational tooth profile of a fiber-separating saw. Collection of TTI, No. 12,1961

Akhmedova S. On the tooth profile of the fiber-separating and fluff-separating saw.Collection of TTI, No. 6, 1958

Downloads

Published

2021-11-06

Issue

Vol. 9 No. 11 (2021): GIIRJ

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.