MODERNIZATION OF THE INSTALLATION MODEL IN ORDER TO BE ABLE TO MEASURE THE DEVIATION OF THE HOLE SURFACE

Authors

  • Isamov Raim Nosimovich Assistant Bukhara Engineering-Technological Institute
  • Zayniyev Xudoyberdi Muhiddinovich Probationer, Teacher Bukhara Engineering-Technological Institute

Keywords:

roundness gauge, geometric shape, profile diagram

Abstract

The article covers modernization of the roundness gauge of BE-20A model, because of which it became possible to measure the deviation from roundness and the deviation of the profile of the longitudinal section

References

Yakushev A.I. Interchangeability, standardization and technical measurement. Moscow:Mechanical Engineering, 1986

Balakshin V.S. and other. Interchangeability and technical measurements in mechanical engineering. Moscow: Mechanical Engineering, 1972.

Downloads

Published

2021-11-16

Issue

Vol. 9 No. 11 (2021): GIIRJ

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.