DIAMOND SMOOTHING EFFORTS AND THEIR CONTROL

Authors

  • Dubrovets Lyudmila Vladimirovna Senior Teacher Bukhara Engineering-Technological Institute
  • Yuldoshev Mirzobek Nurilloevich Probationer - Teacher Bukhara Engineering-Technological Institute

Keywords:

smoothing, force, microroughness

Abstract

The article covers analysis of various methods of cutting forces measurement at diamond smoothing and their description, advantages and disadvantages.

References

Stepanova, T.Yu. Technologies of surface hardening of machine parts: textbook / T.Yu.Stepanova; Ivanovo State Chemical-Technological University. Ivanovo, 2009, p. 64.

Antonyuk F.I., Kalmykov V.V., Fedorov V.A. Influence of initial surface roughness on the

force of diamond smoothing / Science and Education. MSTU named after N.E. Bauman.Electronic journal. 2014, No. 12, p. 171

Grigoriev S.N., Kokhomsky M.V., Maslov A.R. Tooling equipment for NC machines:

handbook / under the general edition by A.M. Maslov. Moscow: Mashinostroenie, 2006, p.554: illustrated.

Manual to the universal dynamometer UDM designed by AUSRI. Moscow: All-Union Scientific Research Institute (AUSRI), 1983, p. 22: illustrated.

Downloads

Published

2021-11-16

Issue

Vol. 9 No. 11 (2021): GIIRJ

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.