«EFFICIENCY OF MULTI-CUT SHAFT MACHINING ON A LATHE»

Authors

  • Tadaeva Elena Vladimirovna PhD, Docent, Namangan Institute of Engineering and Technology, Uzbekistan

Keywords:

Stepped shafts, coaxiality, perpendicularity of ledges

Abstract

The article describes the methods of processing stepped shafts on lathes, the choice of method and cutting tool, the method of processing stepped shafts using thrust cutters is described in detail.

References

Grechishnikov, V. A. Designing a cutting tool: textbook, manual / V. A. Grechishnikov [and others]; under total ed. N. A. Chemborisova. - Stary Oskol : TNT, 2010.

Reference technologist-machine builder. In 2 vols. T. 1 / ed. A. M. Dalsky, A. G. Kosilova, R. K. Meshcheryakov. - 5th ed., revised. and additional - M .: Mashinostroenie-1, 2001.

Makarov, VF Vybor vysokoeffektivnykh abrazivnykh toolov i rezhimov razreza dlya razlichnykh type shlifovaniya zagotovki [Vybor vysokoeffektivnykh abrazivnykh toolov i rezhimy rezanija dlya razlichnykh obshchivanija grinirovaniya zagotovki: uchebnoe, posobie] / VF Makarov. Choice of highly effective abrasive tools and cutting modes for various types of grinding of workpieces. - Stary Oskol : TNT, 2012.

Downloads

Published

2022-05-10

Issue

Vol. 10 No. 5 (2022): GIIRJ

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.